Construction | LIN & LOG |
Rheostat | Potentiometer |
|Standard Variable Resistor|
Photograph © Rapid Electronics
Variable resistors may be used as a rheostat with two connections (the wiper and just one end of the track) or as a potentiometer with all three connections in use. Miniature versions called presets are made for setting up circuits which will not require further adjustment.
Variable resistors are often called potentiometers in books and catalogues. They are specified by their maximum resistance, linear or logarithmic track, and their physical size. The standard spindle diameter is 6mm.
The resistance and type of track are marked on the body:
4K7 LIN means 4.7 k linear track.
1M LOG means 1 M logarithmic track.
Some variable resistors are designed to be mounted directly on the circuit board, but
most are for mounting through a hole drilled in the case containing the circuit with
stranded wire connecting their terminals to the circuit board.
Logarithmic (LOG) track means that the resistance changes slowly at one end of the track and rapidly at the other end, so halfway along the track is not half the total resistance! This arrangement is used for volume (loudness) controls because the human ear has a logarithmic response to loudness so fine control (slow change) is required at low volumes and coarser control (rapid change) at high volumes. It is important to connect the ends of the track the correct way round, if you find that turning the spindle increases the volume rapidly followed by little further change you should swap the connections to the ends of the track.
Rheostats are often used to vary current, for example to control the brightness of a lamp or the rate at which a capacitor charges.
If the rheostat is mounted on a printed circuit board you may find that all three
terminals are connected! However, one of them will be linked to the wiper terminal.
This improves the mechanical strength of the mounting but it serves no function
This arrangement is normally used to vary voltage, for example to set the switching
point of a circuit with a sensor, or control the volume (loudness) in an amplifier circuit.
If the terminals at the ends of the track are connected across the power supply then the
wiper terminal will provide a voltage which can be varied from zero up to the maximum of
Presets are much cheaper than standard variable resistors so they are sometimes used in projects where a standard variable resistor would normally be used.
Multiturn presets are used where very precise adjustments must be made. The screw
must be turned many times (10+) to move the slider from one end of the track to the other,
giving very fine control.
|Photographs © Rapid Electronics|